MCM Electronics

HDTV 80 Mile Deep Fringe Yagi Television Antenna - with 14dB AmplifierMCM Part #: 30-2416  |  Stellar Labs Part #: 30-2416

HDTV 80 Mile Deep Fringe Yagi Television Antenna - with 14dB Amplifier 3.3 stars from 2 reviews.
Login to rate or review this product

Deep Fringe UHF/HDTV Outdoor Antenna w/14dB amplifier
Highly rugged, 70 element directional antenna is engineered to receive UHF signals for digital and high definition television broadcasts from great distances. Corner Yagi design provides exceptional directivity and gain.

Boom mounted 14dB amplifier provides increased signal strength ensuring reliable reception on weak stations, even with long antenna cable runs. This amplifier is powered over the existing coax cable, via an included power inserter which can be located anywhere inside the home.

Product Description

    Features:
  • Boom mounted 14dB signal amplifier
  • Triple boom for exceptional signal gain
  • Pre assembled antenna sections for reduced installation time
  • Heavy duty construction with rugged mast clamps and associated hardware
    Specifications:
  • Nominal range: 80 ~ 100 miles
  • Frequency range: 460 ~ 862Mhz
  • Maximum antenna gain: 18dB
  • Impedance: 75ohm, female “F” connector
  • Overall length: 56”
  • Power requirements, 12VDC, 100mA
  • AC adaptor and coax power inserter included
Click Here to see our expanded line of Stellar Labs Outdoor Antennas.

Product Reviews

  • "Very good antenna for the money" by on 7/7/2014
    Overall: 4.5 out of 5
    Value:
    Quality:
    Top 10 Contributor

    Excellent build quality and performance for the money. I knocked off a star because the instructions were a bit lacking. This was not an issue for me as I've assembled many antennas, but for some it may cause some confusion. From West Liberty Ohio, using a rotor I no problems receiving stations from Lima, Dayton or Columbus.

    All in all, I am very happy and would highly recommend.

  • "Was fine when it worked" by funtime on 5/10/2014
    Overall: 2 out of 5
    Value:
    Quality:

    The amplifier blew out in 2 weeks. It didn't even get wet inside, it just went out. I pried opened the little box afterwards to see if it was fixable (I sure wasn't going to sent the whole antenna back), it was all micro components and almost nothing to it, but no way could I fix it with out having the correct parts. It worked fine when it did work. I then tried to connect the antenna with just a coax to it, and it was below average on reception. I just bought another Stellar Antenna Mounted Amplifier and will try to adapt that to the antenna and see if it helps, it should be in soon. The amplified antennas do make quite a difference. I can get NYC on a clear day from my home which is 90 miles away from NYC. Without a antenna mounted amplifier, it can't do it. I tried a in the house amp and they won't do it either.

  • Rate It!

    Login Here to rate and review this product.

Associated Products

Image of 3' Tripod with Pitch Pads and Lag Screws

30-2500 - 3' Tripod with Pitch Pads and Lag Screws

3' Tripod for Outdoor Antennas Designed for mounting all types of outdoor antennas at the top peak of virtually any roof. These rugged tripods are the industry standard for installation of satellite dishes, small to medium CB and ham radio antennas, TV antennas a...

In Stock

$29.99

Buy Now
Image of 5' Mast Pipe - 18 Gauge - Swaged End

30-2520 - 5' Mast Pipe - 18 Gauge - Swaged End

5' Antenna Mast Pipe Designed for mounting all types of outdoor antennas including satellite dishes, CB and ham radio antennas, TV antennas and more. 18 gauge construction is ideal for smaller antennas, specifically UHF High Definition TV antennas, as it is light...

In Stock

$8.99

Buy Now
Image of 30

30-2525 - 30" Mast Pipe - 18 Gauge

30" Antenna Mast Pipe This short 18 gauge mast pipe is specifically intended for installations that use an antenna rotor. The short length is perfect for mounting above the rotor and attaching the antenna. 18 gauge construction is ideal for smaller antennas, spe...

In Stock

$4.49

Buy Now
Image of Antenna Rotator with IR Remote Control

30-2565 - Antenna Rotator with IR Remote Control

Antenna Rotator System The CM-9521A complete rotator system allows you to rotate your TV antenna, bringing in digital and HDTV programming from all directions. This kit includes the rotor drive unit which physically rotates the antenna, the rotor controller unit ...

In Stock

$119.00

Buy Now
Image of Digital Television Tuner / Recorder with HDMI and Component Output

30-2900 - Digital Television Tuner / Recorder with HDMI and Component Output

High Definition Television (HDTV) Tuner/Recorder The DT-1200 set-top-box receives digital high definition broadcasts for viewing on virtually any television or monitor. Multiple outputs are provided allowing compatibility with many devices, from older analog tel...

In Stock

$79.99

Buy Now
Image of 3' Antenna Tripod

33-10905 - 3' Antenna Tripod

3' Antenna Tripod Mount Light duty tripod is perfect for today's smaller HDTV antennas as well as small communication antennas and satellite dishes. Accepts mast pipes up to 1-5/8" diameter (not included and supports 5' masts with ease.

On Backorder(Expected in 46 days)

$19.99

Buy Now
Image of 38

33-10915 - 38" J-Pole Antenna Mount

38" J-Pole Antenna Mount Versatile all-in-one mount that can be used with antennas or satellite dishes. Can be mounted on the roof, wall, chimney or any other flat surface. J-pipe is reversible from mounting foot for a variety of positioning options. Gray weather...

In Stock

$11.99

Buy Now

Others Also Bought

Image of Bracket Pole Mount VESA75/100

50-14534 - Bracket Pole Mount VESA75/100

Pole Mount Bracket for LCD Monitors Rugged bracket fits any 30mm ~ 60mm diameter pole, whether positioned horizontally or vertically. Great for use with PA speaker and light stands, lighting and stage trusses, and support masts. Pivoting mechanism allows monito...

In Stock

$20.39

Buy Now
Image of Equipment Wall Bracket - Adjustable Length

50-14780 - Equipment Wall Bracket - Adjustable Length

White Equipment Wall Bracket Designed for supporting microwave ovens from the wall, this bracket is ideal for any type of equipment.

In Stock

$13.29

Buy Now
Package Specifications & Dimensions
Weight:7.55 lbs.
Hazardous:No
RoHS Comp:Yes
Warranty:90 days
Need to Return?
Length:31.25 in.
Width:14.5 in.
Height:4 in.
Shipping Information
Extra Shipping Charge:No
Drop Ship:No
Catalog Pages
Catalog/Page:

MCM Cat 57, Page 241

PDF Reference
Datasheet

Requires Adobe Acrobat Reader.

Mfr. Info

Stellar Labs Logo
Mfr. Name:Stellar Labs
Mfr. Part Number:30-2416