MCM Electronics

10" Woofer with Poly Cone and Rubber Surround 100W RMS at 8ohmMCM Part #: 55-2972  |  MCM Audio Select Part #: 55-2972

10" Woofer with Poly Cone and Rubber Surround 100W RMS at 8ohm 4.4 stars from 9 reviews.
Login to rate or review this product

10" Polypropylene Cone Woofer
Low cost general replacement woofer is ideal in a two way cabinets or as a compact subwoofer. It is perfect for a wide variety of home or autosound applications and is ideal for either ported or sealed enclosures.

Also available in 4Ohm Version

Product Description

    General Specifications:
    • Nominal Diameter: 10 inch
    • Rated Impedance: 8 ohms
    • Operating Bandwidth: 50Hz ~ 5KHz
    • Power Handling Capacity: 100W RMS
    • Sensitivity (1W/M): 90 dB
    • Voice Coil Diameter: 1.5 inch
    • Overall frame diameter: 10.00"


    Thiele-Small Parameters:
    • Resonance Frequency Fs: 40 Hz
    • DC Resistance Re: 7.2 ohm
    • Mechanical Q Factor Qms: 2.49
    • Electrical Q Factor Qes: 0.5516
    • Total Q Factor Qts: 0.4516
    • Equivalent Cas air load Vas: 82-27 liters
    • Coil Inductance Le: .5645 mH
    • Efficiency Bandwidth Product EBP 72.51
    • Voice Coil Over Hang X-max 5mm


    Physical Information:
    • Cutout: 9.02"
    • Mounting Depth: 4.29"
    • Basket: Stamped Steel
    • Magnet Type: 24 OZ
    • Cone Material: Polypropylene
    • Surround: Rubber
    • Dust Cap: Polypropylene
    • Damper: Cloth

Product Reviews

  • "Works well for open baffle" by montekay on 12/16/2014
    Overall: 4 out of 5
    Value:
    Quality:

    I'm using four of these, two in each open baffle H-frame for a high-end system using a full range TB 8" driver for 60 Hz to 1500 Hz and an ESS Heil Motion Transformer 1500 Hz up. These low cost 10" drivers are operating from 20 Hz to 60 Hz EQ'ed with a miniDSP 2x4. The other drivers in this system are hundreds of dollars each whereas these are about $10/ea and yet they hold their own very well. They of course have limited output especially approaching 20 Hz due to the relatively shallow 10.5" depth H-frame but for my small apartment, they are plenty.

    One of the four drivers arrived with a rubbing voice coil but MCM promptly replaced it. I have not measured distortion but the drivers are relatively quite and sound reasonably pure for such a low cost driver. A lot of woofers even some very expensive ones tend to be noisy. This is a good test if you have access to a low distortion tone generator, just put in a very low frequency tone 10 ~ 20 Hz and listen for noise. In an ideal driver you wouldn't hear anything.

    The build quality on these is as expected for the price. Very thin stamped frame and even the connector tabs are so thin you have to crimp the quick disconnects slightly otherwise they're too loose. This isn't really a problem however. If you're going to use them very high in frequency (above a couple hundred HZ) the thin stamped frame problem could be overcome by mounting them by the magnet but if you're doing that advanced of a design you would probably be using better drivers.

    These would probably work fairly well in a more conventional box speaker design but will still require EQ to get the most out of them. The miniDSP 2x4 with no box is around $85 plus shipping and is probably the best option for doing both system and room EQ for these. Use several of these in a sealed box with the EQ and you could have a very inexpensive subwoofer with very good performance.

    mk

  • "Good general replacement - but don't expect low bass" by alanmaier on 3/29/2013
    Overall: 4 out of 5
    Value:
    Quality:

    These speakers are a fantastic value for the money. They are great for reviving an old pair of speakers where the original woofers can't be refoamed or are damaged/missing. That was the case for me, as I was resurrecting a vintage pair of speakers where one of the original woofers were removed and lost. I must say these DO have a strong bass output, but they do not have extension to them. They are not compliant nor have the cone travel to be able to reproduce extended bass even with advanced tuning methods. About the lowest extension you are going to get will be in the 60Hz area, and that's with some roll-off. My advice, if you are reviving a decent pair of vintage speakers, these aren't the best driver for you. If you just want strong bass - I can't think of a better woofer for the money.

  • "Perfect replacement bass speaker in spinet organs with sealed boxes" by jbird604 on 3/10/2013
    Overall: 5 out of 5
    Value:
    Quality:

    Sure can't beat this one for the price. Some of the better Lowrey spinet organs from the 80's had a foam-surround 10" woofer in a sealed box or with a small port. We use this driver as a replacement and it sounds awesome. Has more bass punch than the figures suggest. I keep some in stock and don't worry if I run across an organ that came with a 4 ohm woofer, I just pop in one of these. The solid state amps don't mind at all if you use an 8 ohm driver, and the efficiency of this driver is high enough that the loss in amp output doesn't matter. Probably prolongs the life of the amp too. A great speaker at an incredibly low price.

  • "55-2972 - 10" Woofer with Poly Cone and Rubber Surround 100W RMS at 8ohm" by Ryan Bienvenu on 11/29/2012
    Overall: 5 out of 5
    Value:
    Quality:

    Great more sound comes out of it than you would think.

  • "excellent" by D.J.RSB666 on 5/9/2012
    Overall: 4.5 out of 5
    Value:
    Quality:

    excellent quality for the money got 4 to put in 2 new tower speaker i'm build

  • "Good cheap speakers." by faviobarrio on 4/19/2012
    Overall: 4.5 out of 5
    Value:
    Quality:

    They're not super loud but they sound but the two I bought sound good in the 2x10 bass cabinet I put them in. Excellent value.

  • "10in mcm" by ryno4150 on 12/28/2011
    Overall: 2.5 out of 5
    Value:
    Quality:

    i got 4 of these for a bass guitar cab and i wasnt to impressed they worked better wired in parallel .when i ran from the send from my tko peavy amp into the 300 watt gk head it boosted the sound tremendously they will do for now if your gonna build a guitar or bass cab i would recomend getting speakers that are a little more expensive built for musical instruments i wish i would have bought two of the 12 in speakers they have on here for 25$ a piece ,but for 50$ they were a good addition if you only have a 3oo wattt head i would recomend a pre amp and you will get a better sound out of these inexpensive speakers, overall for the price im happy it only took about 4 days to get them during the holiday season i would say thats pretty good

  • "AMAZING!!!!" by omcmusic on 5/31/2011
    Overall: 5 out of 5
    Value:
    Quality:

    I bought 4 of these and put them in some old Marantz boxes and OMG I was blown away and so were the neighbors... Outstanding bass response, BETTER than woofers costing 10 times as much... MCM has done it again... 10 out of 10...

  • "bass cannons" by jackoris66 on 5/29/2011
    Overall: 5 out of 5
    Value:
    Quality:

    I bought two of these 10's and have them mounted in a set of JBL L26 bass reflex cabinets mated to the 55-1080 1" soft dome via a Boston two-way crossover @2.7k. The bass response is outstanding. They sound better & better the more they get broken in. Been using them since October '10. For the money, they can't be beat!

  • Rate It!

    Login Here to rate and review this product.

Associated Products

Image of Red/Black Binding Post Speaker Terminal Cup Round

50-1271 - Red/Black Binding Post Speaker Terminal Cup Round

Round Speaker Terminal Cup Perfect for the recessed mounting in the rear of most speaker systems.

In Stock

$2.59

Buy Now
Image of 1

53-1070 - 1" Titanium Dome Tweeter 60W RMS

This heavy-duty titanium dome tweeter is ideal for any speaker repair, upgrade, or building project. Specifications: Power capacity: 60W/120W RMS/peak Frequency response: 1.5KHz~20KHz Impedance: 8ohm Sensitivity: 94dB 8oz. magnet structure Required cutout...

In Stock

$9.99

Buy Now
Image of 1

53-1080 - 1" Soft Dome Tweeter 30W RMS

This high quality dome tweeter is perfect for repair, upgrade, or new speaker construction. 30W/60W RMS/peak Impedance: 8ohm Sensitivity: 92dB Frequency response: 1.5KHz~20KHz Required cutout: 3" diameter plus notches for connectors Mounting depth: 1¼" ...

In Stock

$4.99

Buy Now
Image of Acoustic Wadding Material

LS00385 - Acoustic Wadding Material

Made of white polyester fiber, this is perfect for internal speaker enclosure dampening, this wadding provides the perfect solution to eliminating problematic low frequency internal resonance. This material is a must for any speaker building or upgrade pro...

In Stock

$4.89

Buy Now

Others Also Bought

Image of Universal TV Stand, For Televisions 32

50-14795 - Universal TV Stand, For Televisions 32" ~ 60"

Universal Television Stand This universal TV stand is perfect for flat panel televisions that were mounted to the wall, but are to be moved to tabletop use. Universal mounting plate attaches to all VESA standard sets from 200x200 through 600x400, and provides a ...

In Stock

$59.99

Buy Now
Image of 10MM Headphones White High Performance Earbud

35-5155 - 10MM Headphones White High Performance Earbud

High Performance Earbud Headphones White Lightweight, stylish, high performance earbuds give crystal clear sound as well as a comfortable fit. Ideal for use with CD, MP3, MP4 and any other small portable audio players.

In Stock

$1.59

Buy Now
Package Specifications & Dimensions
Weight:4 lbs.
Hazardous:Yes
RoHS Comp:Yes
Warranty:365 days
Need to Return?
Length:10.25 in.
Width:10.25 in.
Height:5.5 in.
Shipping Information
Extra Shipping Charge:No
Drop Ship:No
Catalog Pages
Catalog/Page:

MCM Cat 57, Page 160

MCM Cat 56, Page 285

PDF Reference
Datasheet

Requires Adobe Acrobat Reader.

Mfr. Info

MCM Audio Select Logo
Mfr. Name:MCM Audio Select
Mfr. Part Number:55-2972