This multifunction tester is the perfect tool for any security/surveillance installer. It not only lets you test any camera or monitor remotely in both IP and analog installations, but also features a TDR function that locates the specific distance of cable faults from the tester. Now you can significantly reduce your installation time and save hours of labor field focusing cameras, testing network connections, setting up and testing PTZ protocols and settings, troubleshooting signal problems, and testing of CAT5 cable connections with one, easy to use tester (note: IP camera video cannot be displayed on tester LCD).
The tester will send special signals to make the connected POE port flicker at special frequency, which will enable the installers to easily and quickly find the connected ethernet cable. This function can prevent mistakenly insertion or disconnection non-corresponding cable to artificially interrupt network connection.
IP address scan
In digital IP surveillance applications, if IP camera’s IP address is not clear or forgotten; the device cannot be used .IP address scan can quickly search the connected IP camera or other network device’s IP address.
To add an IP camera or other network device to the current network group, the new IP address must not be occupied, otherwise it will cause IP conflicts and stop the equipment normal working. Link monitor can check if the new setting IP address is occupied.
PING is the most conventional network debugging tools (Ethernet port ping test) . It is used to test if the connected IP camera (or any other network equipment) is working normally and the IP address is correct.
It can test the PoE voltage when the POE switch is supplying the POE power to IP camera. It can clearly display the power+ and power- on the ethernet cable pins, each cable pin’s voltage and the failure connection of cable pin series numbers.
Enables cable tester to find the length within a cable where a fault is located.
- 3.5" LCD with 960x240 resolution
- Video signal level meter
- PTZ camera controls
- Unique 12VDC 1A power output to power camera with 3' pigtail
- RS485/RS422 input and data logging
- Network cable tester
- RS232 input
- 3.5mm audio input
- Built in speaker
- Color bar signal generator
- Up to 12 hour battery life
- 4 hour recharge time
- BNC input with 3' M-to-M BNC pigtail (note: newer HD-TVI, HD-CVI and AHD high- def video over coax not yet supported)
- 12VDC 1A output to power camera with 3' pigtail
- 5VDC 2A AC adaptor powers and charges tester
- Li-ion 3.7V 3000mAh rechargeable battery (replacement battery available)
- Carrying case included
Supported PTZ protocols: