MCM Electronics

HTA-250A Amplifier 250w By Bogen Communications (HTA-250A) MCM Part #555-3585

0 stars No reviews yet
This item is Non Cancellable/Non Returnable
This product typically arrives at our warehouse in 21 days, once ordered.

HTA Series Power Amplifier

The Bogen HTA Power Amplifier Series are high performance units employing Power MOSFET technology. The unique characteristics of Power MOSFET circuitry make them ideally suited to power amplifier design, providing far superior performance and reliability compared to other types of transistors. They offer higher efficiency, reduced heat, simpler overall design, reduced size and weight.

Specifications Top

The HTA250A Model supplies 250 watts (RMS continuous output) at less than 0.5% total harmonic distortion from 20 to 20,000 Hz. An input signal of only 500mV is required for full rated output.

  • Power MOSFET circuitry
  • Capable of continuous operation at rated output power
  • Frequency response ±1dB, 20 to 20,000 Hz at full rated output
  • Distortion less than 0.5% THD, 20 to 20,000 Hz
  • Multiple output voltages/impedances available
  • Automatic overload protection
  • Listed to UL Standard 60065 for US and Canada

Rated Output Power: 250W
Total Harmonic Distortion: Less than 0.5%, 20 to 20,000 Hz at full rated output
Frequency Response: ±1 dB, 20 to 20,000 Hz at full rated output
Input Sensitivity: Hi-Z, 500mV; Lo-Z balanced, with optional transformer,150mV
Hum and Noise: 90 dB below rated output
Output Loads: 4 ohms, 8 ohms, 25V, 25VCT, 70V
Output Regulation: Better than 2 dB from no load to full load
Input Impedances: Hi-Z, 50k ohms unbalanced; Lo-Z, 600 ohms, balanced or unbalanced, and 1:1 bridging with optional plug-in transformers
Low-Cut Filter: -10 dB @ 100 Hz
Controls & Indicators: Front Panel — Illuminated On/Off power switch and overload shutdown LED, Rear Panel — Input level control, Slo-Blo fuse, Internal — Low-Cut filter switch
Power Requirements: 120V~, 60 Hz, 5.5A, 520 watts @ Full Rated Output (Idle 60W)
Thermal Emissions (full power): 939.2 BTU/hr
Overload Protection: Electronic overload protection
Electrical: 7A Slo-Blo Fuse
Thermal: Thermostat
Auxiliary Receptacle (not switched): Three-wire grounded*, 300 watts maximum
Dimensions (without removable feet): 19" W x 5-1/4" H x 11" D (48.3 x 13.3 x 27.9 cm)
Front Panel Dimensions: 19" W x 5-1/4" H (48.3 x 13.3 cm)
Finish: Black
Product Weight: 50 lb. (22.7 kg)
Regulatory Approvals: Listed to UL Standard 60065 for US and Canada

*This receptacle will be grounded only if the power amplifier has been grounded properly.

Part Numbers
MCM Part #:555-3585
Bogen Communications Part #:HTA-250A
Package Specifications & Dimensions
Weight:55 lbs.
Warranty:90 days
Need to Return?
Length:22.5 in.
Width:16.25 in.
Height:11 in.
Shipping Information
Extra Shipping Charge:No
Drop Ship:No

Product Reviews Top