MCM Electronics

1.75'' Compression Horn Tweeter - 7.28'' x 14.37'' Horn 300W RMSMCM Part #: 53-1250  |  MCM Audio Select Part #: 53-1250

1.75'' Compression Horn Tweeter - 7.28'' x 14.37'' Horn 300W RMS 3.6 stars from 4 reviews.
Login to rate or review this product

Perfect for PA/DJ speakers, larger horn enables improved efficiency and extended low frequency response.

  • Combination 1.75" titanium dome tweeter attached to a 7.28" x 14.37" horn
  • 24oz. magnet
  • 110W/220W RMS/Peak power capacity
  • Titanium dome
  • 1.75" voice coil
  • 24oz. magnet Specifications:
  • Sensitivity: 103dB (W/M)
  • Impedance: 8ohm
  • Re: 6.3ohm
  • Frequency response: 500Hz~20KHz
  • Outer frame: 7.28" (H) x 14.37" (W)
  • Required cutout: 6.02" (H) x 13.27" (W)
  • Overall depth: 10.28"

Product Reviews

  • "On the safe side= not" by Robert Howard on 9/21/2014
    Overall: 5 out of 5

    Crossing a one inch driver at 1.2 K is nothing but asking for trouble. Even drivers costing triple this generally advise 1.8 to 2K. It's a good cheap driver. If you want bulletproof buy a Selenium D250 phenolic. Any titanium fram will be more fragile.

  • "These are great but let me explain..." by EmersiveAV on 11/24/2013
    Overall: 4 out of 5

    I gave the value for the money a neutral 3 stars because the packaging SUCKS!

    I have ordered these in the past and its the same scenario this time around. I ordered 2 last time and only 1 was usable same again.....As in it came in 1000 pieces this time last time it was busted off right at the neck of the horn flange, I was able to do a glue job on that one but its not in factory condition if you know what I mean..........The diaphragm is huge on these delicate horns and they provide NO foam in the thin box. They are a very good sounding horn when you get a usable pair but this is the 2nd time I had to call in a bad order wich MCM is more then happy to replace at no extra charges. These guys definitely treat you right so no complaints with MCM just if you need a replacement fast this may not be the best choice as it could cost you a lot of time.

  • "Not bad" by dakota140 on 5/11/2013
    Overall: 4 out of 5

    had to push about 500 watts a piece before they blew, I needed to know what I was getting. Im in a rock band and I build my own speakers. im ordering another set. BTW only 2 of the 4 I pushed blew the other two are still holding nicely.

  • "7 x 14 Horn" by mnowak on 2/13/2013
    Overall: 1.5 out of 5

    Ok, the horn is rated at 200 watts (I am assuming music power at this point) with a range of 500Hz - 20kHz. To be on the safe side, I decided to xover at 1.2kHz@18dB/oct. These horns lasted about 1 hour with 20 - 25 watts going to them. They sounded great until they died during the first set. Looks like more cheap Chinese junk that is over rated.

  • Rate It!

    Login Here to rate and review this product.

Associated Products

Image of Gold Plated Speaker Terminals - Square

50-1275 - Gold Plated Speaker Terminals - Square

High powered speaker terminals for use with heavy—duty speaker wire Made of high—quality plastic construction Gold plated binding post Available in round, square and rectangular bi—wire with bridge

In Stock


Buy Now
Image of Acoustic Dampening Pad

LS00916 - Acoustic Dampening Pad

Perfect for internal speaker enclosure dampening, this wadding provides the perfect solution to eliminating problematic low frequency internal resonance. Made from 2/3 sheeps wool and 1/3 polyester fiber, this material is a must for any speaker building or...

In Stock


Buy Now

Others Also Bought

Image of Double Sided Foam Tape

28-955 - Double Sided Foam Tape

•Thousands of uses •Fasten accessories to car dash, etc. •3/4" x 61/2' roll

In Stock


Buy Now
Image of 10MM Headphones White High Performance Earbud

35-5155 - 10MM Headphones White High Performance Earbud

High Performance Earbud Headphones White Lightweight, stylish, high performance earbuds give crystal clear sound as well as a comfortable fit. Ideal for use with CD, MP3, MP4 and any other small portable audio players.

In Stock


Buy Now
Image of VHS Head Cleaner

80-6875 - VHS Head Cleaner

VCR Head Cleaner safely and effectively cleans tape heads and entire tape path Non-abrasive Exclusive cleaning material prevents debris from re-depositing on heads Wet type

In Stock


Buy Now
Package Specifications & Dimensions
Weight:4.69 lbs.
RoHS Comp:Yes
Warranty:365 days
Need to Return?
Length:14.75 in.
Width:10.75 in.
Height:7.75 in.
Shipping Information
Extra Shipping Charge:No
Drop Ship:No
Catalog Pages

MCM Cat 57, Page 177

MCM Cat 56, Page 303

PDF Reference

Requires Adobe Acrobat Reader.

Mfr. Info

MCM Audio Select Logo
Mfr. Name:MCM Audio Select
Mfr. Part Number:53-1250
You deserve some post tax day relief
Save 15% on your order using promo code TXD504