MCM Electronics

10" Woofer with Paper Cone and Cloth Surround - 125W RMS at 8ohmMCM Part #: 55-2951  |  MCM Audio Select Part #: 55-2951

10" Woofer with Paper Cone and Cloth Surround - 125W RMS at 8ohm 4.7 stars from 13 reviews.
Login to rate or review this product

10" Paper Cone Woofer
Low cost general replacement woofer is ideal in a two way cabinets or as a compact subwoofer. It is perfect for prosound applications and is optimized for ported enclosures.

Also available in 4Ohm Version

Product Description

    General Specifications:
    • Nominal Diameter: 10 inch
    • Rated Impedance: 8 ohms
    • Operating Bandwidth: 38Hz ~ 3KHz
    • Power Handling Capacity: 125W RMS
    • Sensitivity (1W/M): 95 dB
    • Voice Coil Diameter: 2 inch
    • VOverall frame diameter: 10.10"


    Thiele-Small Parameters:
    • Resonance Frequency Fs: 38 Hz
    • DC Resistance Re: 7.2 ohm
    • Mechanical Q Factor Qms: 2.7
    • Electrical Q Factor Qes: 0.369
    • Total Q Factor Qts: 0.32
    • Equivalent Cas air load Vas: 62.0 liters
    • Coil Inductance Le: 0.293 mH
    • Efficiency Bandwidth Product EBP 102.98
    • Voice Coil Over Hang X-max 3.5mm


    Physical Information:
    • Basket: Stamped Steel
    • Cutout: 8.90"
    • Mounting Depth: 4.3"
    • Magnet Type: 40 OZ
    • Cone Material: Non-pressed paper
    • Surround: Cloth
    • Dust Cap: Paper
    • Damper: Cloth

Product Reviews

  • "Great little speaker." by papaseven on 11/16/2013
    Overall: 4.5 out of 5
    Value:
    Quality:

    Used it for a mid bass subwoofer replacement and I couldn't be more pleased. Punchy and tight at the same time.
    Great bargain and fast shipping

  • "10" Woofer with paper cone and cloth surround-125w rms at 8ohm" by jimpoli69 on 7/24/2013
    Overall: 5 out of 5
    Value:
    Quality:

    I bought a pair of these woofers as replacements for an old pair of Bose SA-500 speaker cabinets and they absolutely smoke the original woofers in sound and power handling. I also replaced the original tweeter with a 3 1/4 square piezo tweeter and substituted 4.7 uf capacitors instead of the original caps that came in the original cabinets. These new speakers sound amazing and I have been into stereo equipment all of my life...quite amazing actually. At higher volumes I find it is best to drop the midrange control on my vintage Kenwood KR-8010 receiver to -2 db's. More then impressed though, extremely happy with the price and quality of these woofers. Most of the speakers I have owned over the last 30 years never sounded this good.

  • "TS parameters not even close" by teberle on 5/30/2013
    Overall: 3 out of 5
    Value:
    Quality:

    I bought two of these because the TS parameters indicated a good fit for some existing cabinets I had. After breaking them in for ten hours I measured Fs and Qt. Stated Fs was 38 HZ; Mine measured 65.5 and 60.1 Hz. Stated Qt was .38. I measured .95 and 1.00. I obviously can't use these and am sending them back. This is the second time I've received MCM audioselect drivers and had to send them back because of incorrect specs. The units seem to be well built; it's a shame we can't count on the published specs.

  • "Decent sound, great price." by Winman99 on 11/12/2012
    Overall: 4.5 out of 5
    Value:
    Quality:
    Top 25 Contributor

    I have an old set of Wharfdale E50s that had already had the woofers replaced. Although there was nothing wrong with them, years of being exposed to cigarette smoke left them ugly (the mesh grills on the Wharfdales are see-through). These replacements sound fine, and make the speakers look much better. These woofers are slightly louder than the ones I pulled out, but match up well to the replacement mids and original tweeters in the cabinets. I would purchase these again.

  • "Amazingly Good Drivers for the Money" by rbrock00 on 11/11/2012
    Overall: 5 out of 5
    Value:
    Quality:

    I bought two of these woofers to replace the drivers in a pair of 2-way PA speakers, which I recently purchased. MCM was selling these drivers at a great price, so I couldn't pass them up. I'm using them for voice and guitar, with very pleasing results. The sound is very tight, and bass response is good. With large magnets for high power handling, I was almost tempted to use them instead for a 2-10" bass guitar cabinet. I bet they would be great in a properly engineered enclosure. Conclusion: If you need 10" drivers for any purpose, get these. At the price MCM sells them for, you can't go wrong.

  • "Very good buy!" by rcapalac on 10/24/2012
    Overall: 5 out of 5
    Value:
    Quality:

    I bought this woofer to replace my blown woofer on my kustom 10" monitor. The difference between this woofer and the old is night and day! The quality of this woofer is a lot better than the stock woofer. The paper cone is hard and sturdy. I'm definitely getting another one to replace my other monitor woofer.

  • "Excellent bass drivers" by daleadkison on 6/5/2012
    Overall: 5 out of 5
    Value:
    Quality:

    Replaced my tired old bass speakers in my JBL LX900 speaker boxes with these. The holes matched up perfectly so no hassles on the install. The magnets on these things are massive and I noticed they gause my old 36" tv picture tube from 3' away. They work great, in fact a huge improvement. They were innitially reluctant to produce but only took about a week to loosen up and now sound great at all levels of volume.

  • "THE JACK PARRISH BAND REVIEW" by jackparrish on 5/10/2012
    Overall: 4.5 out of 5
    Value:
    Quality:

    I ordered 2 of these to do an experiment on some monitors that I purchased MCM 555-10330 ( Floor Monitor ). The SPL on the monitor woofer was too low for my taste and replaced them with these and it was like night and day.... These things rock now..... I'll order some more in the future for a bass cab. Thnx MCM for a great product.

  • "Excellent Replacement!" by djosech on 3/15/2012
    Overall: 5 out of 5
    Value:
    Quality:

    Put a couple of these in some old Pioneer speakers. They sound great! I would buy them again if I needed to!

  • "Custom speaker builider" by butlerscurry on 2/24/2012
    Overall: 5 out of 5
    Value:
    Quality:

    Great speakers goes with any build

  • "good midbass speaker" by Adarius on 1/4/2012
    Overall: 5 out of 5
    Value:
    Quality:

    I have bought 4 of these with two per speaker in a WMTMW configuration speaker. These being used as the W (woofer) on the bottom and top. The sound is of very good quality. The rated power is about right as I have a crown amp power the four with about 500watts rms. The sound is great. It's not ridiculously low. Just a good midbass sound. Great for most types of music. I have it tuned to the 38hz stated. I would suggest to get a driver to go lower or put out more xmax if more bass is desired. As is; this is a great sounding and very inexpensive driver. It is a great value. It is very comparable to eminence beta's, In fact, I actually prefer the mcms.

  • "Sound Design Engineer / Professional Sound Installation" by dizzo007 on 7/7/2011
    Overall: 5 out of 5
    Value:
    Quality:

    Great sounding speakers.. Designed a line array system using two 10" woofers in a ported configuration with a 2" driver on a waveguide for the high frequencies in each cabinet. Great low end response and very clear mids.. With a properly designed cabinet these speakers will definitely render great results.

  • "Great as a sub driver in a PA / DJ application" by dwayne.newton1 on 6/9/2011
    Overall: 5 out of 5
    Value:
    Quality:
    Top 25 Contributor

    I designed a three way system that uses this in it's own box and four 5 inch speakers 55-1595 in a three row, two column configuration, with titanium dome super tweeters in the top row. They really do the job of adding depth without being rediculously bass heavy (as in boomy). I found a vented sub enclosure that is tuned to 38 Hz and it will easily handle a medium sized hall when used with a decent full range speaker system for the top end. Although I haven't done so I think it would also work very well in a more typical 2-way system.

  • Rate It!

    Login Here to rate and review this product.

Associated Products

Image of Speaker Grill Mounting Hardware

50-1235 - Speaker Grill Mounting Hardware

For use with round speaker grills Supports most types of grills Made of high-impact plastic Black Four per package

Limited Stock

$0.99

Buy Now
Image of Acoustic Wadding Material

LS00385 - Acoustic Wadding Material

Made of white polyester fiber, this is perfect for internal speaker enclosure dampening, this wadding provides the perfect solution to eliminating problematic low frequency internal resonance. This material is a must for any speaker building or upgrade pro...

In Stock

$4.89

Buy Now

Others Also Bought

Image of 15

55-2953 - 15" Woofer with Paper Cone and Cloth Surround - 200W RMS at 8ohm

15" Paper Cone Woofer Low cost general replacement woofer is ideal in a two way cabinets or as a subwoofer. It is perfect for prosound applications and is ideal in ported or sealed enclosures.,/p> Also available in 4Ohm Version

In Stock

$31.49

Buy Now
Image of 12

55-2952 - 12" Woofer with Paper Cone and Cloth Surround - 175W RMS at 8ohm

12" Paper Cone Woofer Low cost general replacement woofer is ideal in a two way cabinets or as a subwoofer. It is perfect for prosound applications and is ideal for either ported or sealed enclosures. Also available in 4Ohm Version

In Stock

$18.89

Buy Now
Image of Switch Mode 12VDC, 5A AC Adaptor

28-11650 - Switch Mode 12VDC, 5A AC Adaptor

Highly efficient power supply is ideal for charging and powering a variety of portable devices. Close output regulation ensures precise 12VDC output, even at very small loads, making this an ideal replacement for virtually any 12VDC adaptor. Universal input voltag...

In Stock

$20.99

Buy Now
Package Specifications & Dimensions
Weight:6.3 lbs.
Hazardous:Yes
RoHS Comp:Yes
Warranty:365 days
Need to Return?
Length:11 in.
Width:11 in.
Height:6.75 in.
Shipping Information
Extra Shipping Charge:No
Drop Ship:No
Catalog Pages
Catalog/Page:

MCM Cat 57, Page 160

MCM Cat 56, Page 285

PDF Reference
Datasheet

Requires Adobe Acrobat Reader.

Mfr. Info

MCM Audio Select Logo
Mfr. Name:MCM Audio Select
Mfr. Part Number:55-2951