This energy efficient work light with wide base and cushioned handle make this a sturdy addition to any work bench. The 8 foot cord gives you lots of flexibility in placement.
I too mounted this light above my workbench. The floor stand is easy to remove and bolting the U-bracket to the underside of my shelving was easily done with a #10 machine screw and a couple of fender washers. I did open up the unit and installed a small toggle switch in the middle-bottom on the side opposite the power cord. There is just enough room to add it if you are careful and use a small enough switch. I also replaced the power cord with a much smaller gauge cable from an old PC. The original cord was rather "heavy duty" and inflexible for only having to carry 10 watts. The only negative point I can make about this unit is that it generated a bit of RFI on a nearby VHF radio, no doubt from the built-in switching supply. Overall, the bright illumination of this unit really helps when working on small SMD circuits.
Small, bright, lightweight. Mounted over my workbench for working in small precision parts- to replace holagen 250 watt lamp which raised the room temperture 25 degrees. Grey frame on front of LED is only 4.5 in x 3.5 in. - it is really bright for the size. LEDs are super!
Login Here to rate and review this product.
29-5840 - 45 LED Portable Work Light with Tripod
Illuminate any work area with this portable work light. The 45 LEDs use very little energy and generate almost no heat. The tripod adjusts from 3 - 6 feet with a simple twist. It’s rated IP44 water resistant for additional safety.
MCM Cat 57, Page 866
MCM Cat 56, Page 774
I have used MCM for many years and would give high recommendation for getting the job done right.