MCM Electronics

HDTV 70 Mile Deep Fringe Yagi Television Antenna By Stellar Labs (30-2415) MCM Part #30-2415

5 stars 6 reviews
MSRP: $79.95
You Save: $43.96 (55 %)
Qty.Volume Price

Deep Fringe UHF/HDTV Outdoor Antenna
Highly rugged, 70 element directional antenna is engineered to receive UHF signals for digital and high definition television broadcasts from great distances. Corner Yagi design provides exceptional directivity and gain. Note: Vertical mast pipe shown is not included.

Click Here to see our expanded line of Stellar Labs Outdoor Antennas.

Specifications Top

  • Triple boom for exceptional signal gain
  • Pre assembled antenna sections for reduced installation time
  • Heavy duty construction with rugged mast clamps and associated hardware
  • Nominal range: 70 ~ 80 miles
  • Frequency range: 460 ~ 862Mhz
  • Maximum gain: 18dB
  • Impedance: 75ohm, female “F” connector
  • Overall length: 56”

Part Numbers
MCM Part #:30-2415
Stellar Labs Part #:30-2415
Package Specifications & Dimensions
Weight:7.05 lbs.
RoHS Comp:Yes
Warranty:90 days
Need to Return?
Length:31.25 in.
Width:14.5 in.
Height:4.25 in.
Shipping Information
Extra Shipping Charge:No
Drop Ship:No

Product Reviews Top

  • by ke4kto

    on 11/13/2015

    Outstanding Deep Fringe Antenna

    Overall: 5 out of 5

    When I went from an antenna receiving 5 channels to cable in the 80's , Cable TV cost $28.00 month for all channels. When cable went to $180.00 a few months ago, I cut the cable and installed this Antenna. I live in Statesville NC about 40 miles from Charlotte and 40 miles from Winston-Salem. With this antenna ten feet above my roof I get 64 Channels. There are movie channels, comedy channels, retro channels, and all 4 networks. ABC, CBS, NBC, PBS, Home Shopping, indipendent showing Lassie, Hop Along Cassidy, Father knows best and more. Best of all it is all free and I am not paying the cable company one red cent. This antenna is outstanding. It is easy to put together and easy to install. I will never go back to cable or satellite TV again. Their prices are astronomically high, their service is terrible and they have no idea how to maintain their systems so you dont get pixelization and ghosting. You cannot go wrong with this antenna. I am 70 years old and installing it was very easy. Just be very careful up on the roof. For the pole mount I used an old Satellite dish tripod mount that wqs left on the roof. The TV antenna pole slips right in. I do not use a rotator because I do not need one, but a rotator would be simple to install. Cut the cable and tell the cable or dish company where to go. There are more free channels on the air than you realize. I am saving enough money each month to buy a nice economy used car.

  • by mattdp

    on 9/11/2015

    Great build

    Overall: 5 out of 5

    Very impressed with the design and build quality. The directors are all punched through the booms, the corner reflector clips in place and the three booms mount into the plastic piece. Takes a minute to assemble, but there's nothing that's going to snap off or get bent up once it's in place (can't be said of all antennas).

    I'd estimate the gain to be in the neighborhood of 14dBd (depending on frequency of course). Used it on two installs, both about 65mi (preamplified, flat terrain) and it got good signal on all channels.

  • by antennadog

    on 4/27/2015

    Very good performer.

    Overall: 4.5 out of 5

    Receiving WBGU d.t. 27 from ohio 60 miles away. day and night reception from Ft.Wayne,in. Plus lima,ohio and 26 from Auburn,in.

  • by jwolf23

    on 10/24/2013

    like no other for the money

    Overall: 5 out of 5

    its huge, cost effective and you'll get plenty of channels whether its inside or outside the house. it wont disappoint. nowhere else will u get an antenna this size for 40 + s&h. ABSOLUTELY NOWHERE

  • by freddybear

    on 10/20/2013

    70 mile deep fringe yagi!

    Overall: 5 out of 5

    I wanted a high gain uhf antenna to hook up in the attic as a backup TV reception. If my rooftop antenna blows down or fails I hook this attic antenna in to the splitter amplifier in the basement! I assembled it in the kitchen all but the reflectors since they were too wide to fit through the attic pull down stairway opening. I drilled two holes through a inch and one half PVC pipe and screwed it to a 2x4 cross brace in the attic and mounted the antenna too the pipe. I was able to rotate it by hand to get the best signal and the reception was fantastic except channel 2 which was transmitting on VHF channel 12 in Chicago. I couldn't receive that so I put a high quality splitter at the antenna and hooked up an old VHF rabbit ear antenna with the elements extended about 18 inches and behold! All channels came in perfect including channel two! My back up system is just as good as the rooftop antenna! Thanks too Stellar Labs well designed and constructed antenna! You cant go wrong with this antenna and the value for the price is exceptional!

  • by wb0rxx

    on 9/9/2013

    A heavy-duty antenna that works well

    Overall: 5 out of 5
    Top 25 Contributor

    I purchased this antenna to replace the MCM 30-2155. While there was absolutely nothing wrong with the original antenna, I wanted a bit more gain for some of my more distant stations. I also liked the fact that the new antenna was balanced and does not sag at all on the mast. The antenna assembled very easily in about 15 minutes. The instructions are not the best, but most people should have no problem comparing the images with the antenna parts. I especially liked the "improved" antenna feed point. This seems to be much better engineered over the original 30-2155. Not described in the manual, the antenna has a small, black plastic cable clamp attached to the bottom support. I repositioned this to the rear end of the support and inverted it. This change permits a smooth transition from the feed point to the mast and provides good support of the RG-6 cable. There is also a minor typo/error in the manual that at first made my heart skip a beat. It states the antenna covers channels 21-69. In reality, it does work on channels as low as 14 (470 MHz.) Also, the main drawing shows the mast clamping very close to the rear end of the bottom support. This was not the case on my antenna as the clamp was closer to the center. This location provides an almost perfect balance of the antenna. One thing I really liked during construction were the "wing nuts." They are really regular nuts with a built-in wrench. As such, it is easy to secure them with either your hand or an adjustable wrench. Overall, I am seeing a bit more gain on my weaker stations and the beam width is sharper too. The antenna is constructed out of heavy duty aluminum and steel so it should withstand a Minnesota winter without any problem.

Associated Products

Image of 3' Tripod with Pitch Pads and Lag Screws

30-2500 - 3' Tripod with Pitch Pads and Lag Screws

3' Tripod for Outdoor Antennas Designed for mounting all types of outdoor antennas at the top peak of virtually any roof. These rugged tripods are the industry standard for installation of satellite dishes, small to medium CB and ham radio antennas, TV antennas a...

In Stock


Buy Now
Image of 5' Mast Pipe - 18 Gauge - Swaged End

30-2520 - 5' Mast Pipe - 18 Gauge - Swaged End

5' Antenna Mast Pipe Designed for mounting all types of outdoor antennas including satellite dishes, CB and ham radio antennas, TV antennas and more. 18 gauge construction is ideal for smaller antennas, specifically UHF High Definition TV antennas, as it is light...

In Stock


Buy Now
Image of 30

30-2525 - 30" Mast Pipe - 18 Gauge

30" Antenna Mast Pipe This short 18 gauge mast pipe is specifically intended for installations that use an antenna rotor. The short length is perfect for mounting above the rotor and attaching the antenna. 18 gauge construction is ideal for smaller antennas, spe...

In Stock


Buy Now
Image of Antenna Rotator with IR Remote Control

30-2565 - Antenna Rotator with IR Remote Control

Antenna Rotator System The CM-9521A complete rotator system allows you to rotate your TV antenna, bringing in digital and HDTV programming from all directions. This kit includes the rotor drive unit which physically rotates the antenna, the rotor controller unit ...

On Backorder(Expected in 21 days)


Buy Now
Image of 3' Antenna Tripod

33-10905 - 3' Antenna Tripod

3' Antenna Tripod Mount Rooftop tripod mount is perfect for all types of outdoor television antennas as well as small communication antennas and satellite dishes. Accepts mast pipes up to 1-5/8" diameter (not included and supports 5' to 10' masts with ease. Note:...

In Stock


Buy Now
Image of 38

33-10915 - 38" J-Pole Antenna Mount

38" J-Pole Antenna Mount Versatile all-in-one mount that can be used with antennas or satellite dishes. Can be mounted on the roof, wall, chimney or any other flat surface. J-pipe is reversible from mounting foot for a variety of positioning options. Gray weather...

In Stock


Buy Now

Others Also Bought

Image of Double Sided Foam Tape

28-955 - Double Sided Foam Tape

•Thousands of uses •Fasten accessories to car dash, etc. •3/4" x 61/2' roll

In Stock


Buy Now
Image of 10MM Headphones White High Performance Earbud

35-5155 - 10MM Headphones White High Performance Earbud

High Performance Earbud Headphones White Lightweight, stylish, high performance earbuds give crystal clear sound as well as a comfortable fit. Ideal for use with CD, MP3, MP4 and any other small portable audio players.

In Stock


Buy Now
Image of 22

22-24120 - 22" Black Tactical Weatherproof Equipment Case

Durable equipment case provides maximum shock protection for contents making it useful for instruments, audio/video equipment, tactical gear, photographic equipment and test equipment. Pre-cut cubed foam insert (top layer only) is easily customizable to fit nearly...

In Stock


Buy Now
Free Super Saver Shipping on orders over $39 for a Limited Time!
Free Super Saver Shipping on orders over $39 for a Limited Time!